【
6-14
】
ENGINE
●
Remove the output shaft [2].
●
Remove the right crank case bolts.
●
Remove the right crank with special tool.
●
Remove the collar [1].
●
Remove the drive bevel gear [2].
●
Remove the dowel pins [2].
●
Remove the oil sump filter [3].
NOTE
Loosen the crankcase bolts diagonally with the smaller sizes first.
NOTE
* The crankcase separator plate is parallel with the end face of the
crankcase.
* The crankshaft must remain in the left crankcase half.
Summary of Contents for DL702
Page 1: ... 0 0 FOREWORD INDEX ...
Page 88: ... 7 13 ELECTRICAL SYSTEM Wiring Diagram ...
Page 89: ... 7 14 ELECTRICAL SYSTEM Wiring Diagram ...
Page 90: ... 7 15 ELECTRICAL SYSTEM NOTE ...
