Dinli DL702, Service Manual

Page: 25 / 99

【
3-3
】
BRAKE
Brake Fluid Level Inspection
● Position the reservoir horizontal, and check the fluid level in the
reservoir.
If the fluid level is lower than the lower level line, check for fluid
leakage of the brake line, and add the fluid as follow.
○
Removal the reservoir cap, and fill the reservoir to the upper level
line [A] in the reservoir with the same type and brand of the fluid
that is already in the reservoir.
And then install the reservoir cap.
● Tighten:
Torque - Reservoir Cap Screws: 1.5 N-m (0.15 kg-m, 13 in-lb)
Brake Fluid Change
● Remove the reservoir cap and the rubber cap on the bleed valve.
● Attach a clear plastic hose to the bleed valve on the caliper, and
run the other end of the hose into a container.
● Fill the reservoir with new brake fluid.
● Change the brake fluid as follows:
○
Open the bleed valve [D].
○
Squeeze the brake lever and hold it [B].
○
Close the bleed valve [C].
○
Release the brake level [A].
● Check the fluid level in the reservoir often, replenishing it as
necessary.
● Repeat this operation until fresh brake fluid comes out into the
plastic hose or the color of the fluid change.
WARNING
Change the fluid in the brake line completely if the fluid must be
refilled but the type and brand of the fluid that is already in the
reservoir are unidentified.
A
B
NOTE
○
If the fluid in the reservoir runs completely out any time during
fluid change, air will enter the line, and the system must be
bled.
WARNING
Do not mix two brand of fluid. Change the brake fluid in the
brake line completely if the fluid must be refilled but the type and
brand of the brake fluid that is already in the reservoir are
unidentified.