Dinli DL-901, Service Manual

Page: 87 / 136

【
6-30
】
ENGINE
Install MAG Cover
●
Apply grease around Shaft 1 and 2, and fit Reduction Gear 1
and 2 in position correspondingly.
●
Apply grease to gears.
●
Fit Stator Coil into MAG Cover.
Tightening Torque: 5.5 – 6.5 N-m
Fastener : M5 X 30L 3 pcs.
●
Route the coil wiring along the groove and fix Pulsar Coil
over the wiring.
Tightening Torque: 2.5 – 3.5 N-m
Fastener : M5 X 12L 2 pcs
.
●
Fit Plug 1 and 2 (MAG Cover).
Tightening Torque: (Plug 1) 10 – 12 N-m (Plug 2) 3 – 5 N-m
Note:
Make sure O-ring is attached onto Plug (MAG Cover).
Set the harness grommet into the groove.
●
Fit Gasket (MAG Cover) onto Crankcase after spot applying
TB #1215 onto the Crankcase surface.
●
Fit MAG Cover and tighten bolts.
Tightening Torque: 9 – 11 N-m
Fastener : M6 X 35L 11 pcs.
Fit Oil Delivery Pipe
Tightening Torque: 15 – 21 N-m
Note:
Fit gasket on both sides of banjo (fitting).
Set the rubber pipe in horizontal direction.