Dinli DL-901, Service Manual

Page: 39 / 136

【
3-14
】
BRAKE
Brake Disc Removal
●
Remove the rear caliper, unscrew the banjo bolt and
remove the brake hose from the caliper.
●
Loose the brake disc mounting bolts [A] and nut [B].
●
Support the vehicle.
●
Remove the rear wheel (see Wheel Removal).
●
Remove the disc.
Brake Disc Installation
●
The disc must be installed with the marked side [A] facing
toward the steering knuckle.
●
Tighten:
Non-permanent Locking Agent - Disc Mounting Bolts
Torque - Disc Mounting Bolts: 37N-m(3.8kg-m, 27ft-lb)
●
After installing the discs, check the disc runout (see Disc
Runout). Completely clean off any grease that has gotten on
either side of the disc with a high flash point solvent.
●
Check the disc wear (see Disc Wear).