Dinli DL-901, Service Manual

Page: 32 / 136

【
3-7
】
BRAKE
Brake Pad Removal
●
Remove the front wheel (see Wheels/Tires chapter).
●
Remove the caliper (see Caliper Removal)
●
Push the anti-rattle spring [A], remove the pads [B] [C].
Brake Pad Installation
●
Push the caliper piston in by hand as far as it will go.
●
Be sure that the anti-rattle spring is in place.
●
Install the pads
●
Tighten:
Torque - Pad Mounting Bolts:18N-m(1.8kg-m,13.0ft-lb)
WARNING
△
Do not attempt to drive the vehicle until a full brake level
is obtained by pumping the brake level until the pads are
against each disc. The brakes will not function on the first
application of the level if this is not done.
Brake Pad Wear Inspection
●
Check the lining thickness [A] of the pads in each caliper.
If the lining thickness of either pad is less than the service
★
limit [B], replace both pads in the caliper as a set.
Pad Lining Thickness:
Standard: 4.5mm
Service Limit: 2mm