DINGO 150, User Manual

Page: 21 / 179

BASIC CONTROL
1. Socket for outer equipment 12V: Located on the panel behind the gas tank, designed for 12V
mains supply of peripheral equipment. Operating voltage: 12V. Total current: 5
А. Maximal total power: 60 W.
Intended for low-current products!
2. Wheel grips of a wheel and a gas cock heating switch. Indicator of switching on the wheel grips
and the gas cock heating is a red LED flashing on a button. There are three switch modes:
'0' - wheel grips is off;
'LO' - A medium mode of wheel grips heating is on;
'HI' - A maximal mode of wheel grips heating is on.
Right lever controls:
1. Device for engine emergency stop. Intended for snowmobile engine emergency stop. Is
activated while pulling out a pin.
2. Throttle control. For acceleration press the throttle control. For deceleration release the
throttle control. Before start of the engine check a throttle control and make sure that it
works smoothly. Make sure that the control returns back to idle position as soon as it
becomes free.
3. Cord with a pin and a carbine. For your safety while driving the snowmobile always
fasten a strap of the engine emergency stop device cord to your right arm's wrist. It
will help
to kill the snowmobile engine and the snowmobile itself in case of falling or any other case of emergency.
Socket for outer equipment is intended for low-current products. Not intended for usage
of consumers having power of 60 W and current rate of more than 5 A.
Don't let a headlamp light and additional electric appliances connected to a lighter if the
engine doesn't work. It
may lead to a full or partial battery discharge.
20
BASIC CONTROLS