OPERATOR
’S MANUAL
with Maintenance Information
Function Tests
25
the control panel.
⊙
Result: The front wheels should turn in the
direction that the blue triangle points on the
control panel and the rear wheels should
turn in the direction that the yellow triangle
points on the control panel
38 Press and hold the function enable switch
on the proportional control handle.
Depress the thumb rocker switch in the
direction identified by the yellow triangle
on the control panel.
⊙
Result: The front wheels should turn in the
direction that the yellow triangle points on
the control panel and the rear wheels
should turn in the direction that the blue
triangle points on the control panel
39 Push the steer mode select button for
steer CS mode (Crab Steer mode).
40 Press and hold the function enable switch
on the proportional control handle.
Depress the thumb rocker switch on top of
the proportional control handle in the
direction identified by the blue triangle on
the control panel.
⊙
Result: The front wheels should turn in the
direction that the blue triangle points on the
control panel and the rear wheels should
turn in the direction that the blue triangle
points on the control panel
41 Press and hold the function enable switch
on the proportional control handle.
Depress the thumb rocker switch in the
direction identified by the yellow triangle
on the control panel.
⊙
Result: The front wheels should turn in the
direction that the yellow triangle points on
the control panel and the rear wheels
should turn in the direction that the yellow
triangle points on the control panel
Test Drive and Braking
42 Press and hold the function enable switch
on the proportional control handle.
43 Slowly move the proportional control
handle in the direction indicated by the
blue arrow on the control panel until the
machine begins to move, then return the
proportional control handle to the center
position.
⊙
Result: The machine should move in the
direction that the blue arrow points on the
control panel, then come to an abrupt stop.
44 Press and hold the function enable switch
on the proportional control handle.
45 Slowly move the proportional control
handle in the direction indicated by the
yellow arrow on the control panel until the
machine begins to move, then return the
proportional handle to the center position.
⊙
Result: The machine should move in the
direction that the yellow arrow points on the
control panel, then come to an abrupt stop.
Note: The brakes must be able to hold the
machine on any slope it is able to climb.
Test Limited Drive Speed
46 Press the lift function select button. Raise
the platform approximately 3.5
m from the
ground.
47 Press the drive function select button.
48 Press and hold the function enable switch
on the proportional control handle slowly
move the proportional control handle to the
full drive position.
⊙
Result: The maximum achievable drive
speed with the platform raised should not
exceed 12.5cm/s.
¤
Result: If the drive speed with the platform
raised exceeds
12.5cm/s, immediately tag
and remove the machine from service.
Summary of Contents for JCPT2223RT
Page 3: ......
Page 17: ...OPERATOR S MANUAL with Maintenance Information Decals 12 ...