Dillon EDXtreme, User Instructions

Page: 27 / 68

EDXtreme User Instructions 25
4 EDX Setup
To begin using the EDX, it is recommended that you set it up to suit your specific needs
and equipment.
Access the SETUP menu from the display screen by using the soft keys. Press the
Arrow key to move to the next display screen. Press the Setup soft key (refer to Figure
3.2 ). See Common Configurations on page 56 to view some common configurations.
Figure 4.1 Operator Setup Menu for the EDXtreme
Setup
PtFmt Misc. About Test
Batt A-D Disp Keys Comm Setpts
Setpt1 Setpt2
Cell Com 1
Press KEY to
test. Press ESC
key to exit
View Counts and
Cal. factor
Run display test
View Battery
Voltage and
temp.
Device Calib. 0.Load Zero Ntwrk
View Radio
information
View Dead load
Analysis
View Over load
counter and log
Points Re-Cal Print
Print Calibration
report
To view when
calibration is due
View all
Calibration
points
Display Device
info, SN, FW and
PN
Flash Zero Contr BLite
Inten Mode
Selected
Backlight ON,
OFF or Timer
operation
If Timer enabled
then: Enter time
in Seconds
Choose Motion
Reset Timer: YES
or NO
Choose backlight
intensity: 1- 10
Adjust Contrast
Up or DOWN
Choose Zero Key
clears Peak: YES
or NO
Set AZT (div): .5
Set Motion
Range (div): 1
Enable Key
Blink/: YES or
NO
Choose default
print format: 1 - 5
Set Filter
(*40)
Date/Time
(Enabled,
Disabled)
Continued on
the next page
See Figure 4.1 for communicator setup and corresponding flow diagram.