12
ACCESSING FACTORY PROGRAMS
There are four methods for recalling Programs. The first method uses
the <UP> and <DOWN> Cursor keys. The procedure is as follows:
• From the title screen, press the <UP> Cursor key. Note that the
Program shown in the display changes and the number shown
in the LED display increments by one each time the <UP>
Cursor key is pressed. Pressing the <DOWN> Cursor key caus-
es the reverse to occur: the Valve FX decrements through the
Programs in memory.
• To scroll at high speed through the Programs in memory, press
and hold either the <UP> or <DOWN> Cursor key.
The second method for changing Programs is the same as the first,
except that instead of using the Cursor <UP> and <DOWN> keys,
turn the Data wheel. Turning the Data wheel clockwise from the title
screen increments through Programs, while turning it counter-clock-
wise decrements through Programs.
The third method uses the optional Control One foot controller.
NOTE
:
When you send a Program change to the Valve FX using
the optional Control One foot controller, any unstored modifica-
tions you have made will be lost.
The procedure is as follows:
• Press the Select switch (in the upper right corner of the Control
One foot controller) once. The foot controller display reads:
• Using the numbered foot switches, enter the number of the
Program you want to recall. If the Program number is only two
digits long, press the Select switch again to accept the selected
Program number.
The fourth method is through the use of MIDI. This method will be
covered later in the Utilities section of this manual, pg. 44.
PROGRAM NUMBER
Section 2 - Basic Operations
Valve FX Owner’s Manual
