Page 3.4
Rev C August 2009
3. Getting Started
Digital Projection
TITAN sx+600/700.
User Manuall
Adjusting the projected image
Picture settings
Press a
key, followed by
and
to adjust these picture settings:
Brightness
BRI
Contrast
CON
Saturation
SAT
Phase
PHASE
Aspect ratio
ASPECT
Geometry settings
Press Keystone
KEYST
followed by
and
to adjust the keystone correction.
Press Position
POS
(for all inputs except DVI)
followed by
,
,
and
to adjust the picture position, for images
smaller than the DMD.
Switching the projector off
Press POWER
on the remote control or keypad, and hold for 3 seconds,
to switch the projector OFF.
•
•
•
•
Notes
The
Saturation
control is
available for Composite, S-
Video and Component inputs
only.
The
Phase
control is available
for RGB inputs only.
For more detailed information
about:
- using the control keys on the
remote control or keypad,
- using the menus,
see the next section:
Controlling the projector
.
For all adjustments that require
more than one key to be
pressed:
- after 10 seconds, if no
adjustment has been made,
the indicator will go out and
the adjustment key must be
pressed again.
- to end the adjustment before
10 seconds has elapsed, press
a different adjustment key, or
press the Exit key.
Always allow the lamp to cool
for 5 minutes before:
- disconnecting the power
- moving the projector
- changing the lamp
Downloaded From projector-manual.com Digital Projection Manuals
