Digital Projection Mercury Quad Series, Installation And Quick Start Manual

Page: 78 / 130

page 70
Digital Projection Mercury Quad Series
Operating Guide
USING THE PROJECTOR
Rev A March 2017
Setup menu continued from previous page
•
Infrared Remote
Set to
Off
if you wish to disable the remote control.
•
IR Code
The projector and the remote control need a matching IR code: a two-digit number
between 00 and 99 .
The default IR code is 00 . This is also a master code, which, if assigned to a remote,
will work regardless of the value assigned to the projector.
To assign an IR code for the projector:
1. Select
IR Code
.
2. Use the
UP
and
DOWN
arrow buttons to change the values.
To assign an IR code for the remote:
1. Press and hold the
ADDR
button on the remote until the indicator starts flashing.
2. Release the
ADDR
button and while the indicator is still flashing, enter a two-
digit address using the numeric input buttons. The indicator will flash three times
quickly to confirm the change.
•
IR Code Reset
Use this command to unassign an IR code from the projector. This will revert the
IR Code
value to 00.
To unassign an IR code from the remote control,
•
Press and hold
ALT
and
ADDR
simultaneously until the indicator flashes to
confirm the change.
•
OSD Settings
Access this submenu to adjust the appearance and position of the on-screen display.
•
Memory
Access this submenu to save up to four presets containing custom combinations of
image settings, or to recall a saved preset.
Highlight the
UP
arrow at the top of the page and press
ENTER/OK
to go back to the
first
Setup
menu page.
Notes
If you turn the remote control off,
you can only turn it back on again
from the control panel or via the
Projector Controller application.
The Projector Controller software
is available for download from the
Digital Projection website, free of
charge.
A wired remote control will also be
disabled if
Infrared Remote
is set
to
Off
.
Setup
Infrared Remote
IR Code
IR Code Reset
Memory
OSD Settings
p
On
0
u
u