page 14
Digital Projection M-Vision 930 Series
Installation and Quick-Start Guide
CHANGING THE FILTERS
Rev C February 2015
Changing The Filters
The projector contains four identical replaceable filters accessible via the air inlets.
To replace the filters on the right-hand side of the projector:
1. Loosen the two screws on the cover of the air inlet and remove the cover.
2.
Pull out the old filters.
3.
Insert the new filters into the slots.
4.
Reattach the cover and tighten the screws.
Notes
Before changing the filters,
always make sure the projector
is switched off and fully
disconnected from its power
supply.
When changing the filters, avoid
using excessive force as this may
damage the equipment.
