22
7
Brown
(+) Brake or
Clutch
This wire senses when you step on the Brake. It
allows the system to enter “Start” mode. The wire will
be +12V as you depress the brake pedal, and will be
ground when release brake.
8
Blue
(-)
Optional:
External High Current Relay Control for Ignition
#2
***see page 29
9
Green
(-)
Optional:
External High Current Relay Control for Ignition
#1
***see Page 29
10
Yellow
(AC+)
Vehicle
Tachometer
Sense wire
This wire tells the PBS Module if the engine is running
or not. It requires at least 3 volts (AC) and 20 Hz (or
faster) at idle. Common Tach references are: the
negative side of an injector, the negative side of an
Ignition Coil, or the Engine Control Module (ECM).
** See TACH Learn Mode Pg.________
HIGH CURRENT NOTICE:
For Heavy Duty / High Current Ignition circuits requiring greater than 40 AMPS.
On vehicles with dual AC, extensive lighting or other high current accessories with
higher then normal current requirements you must use the additional external high-
current relay schematic found on Page
29
Neutral Safety Switch Interface
Connect this wire to the PARK/NEUTRAL
switch in the vehicle as shown in Figure A.
This wire will test with ground with the gear
selector either in PARK or NEUTRAL.
Connected properly, the vehicle will only
start while in PARK or NEUTRAL.
Figure A
Summary of Contents for 2GO KEYLESS iKEY RS
