6
5. Route the wires of the harnesses along factory wiring to areas in which the
different connections will be made. DO NOT plug the two wiring harnesses into
the Control Module until all connections have been completed. When running
the harness wires through the vehicle, be careful to run them where they could
be damaged or shorted to GROUND. Keep them away from ALL MOVING
PARTS of the vehicle or where high heat could damage their insulation. Always
protect the harness wires where they pass through holes in metal panels by
using rubber grommets. Secure wires to factory harnesses using zip ties and
use wire loom where appropriate.
6.
Once the control unit is connected, begin function tests only after verifying and
ensuring all wires have been connected and insulated properly. Do not power
up the module before it is properly grounded. If the unit is powered before
being grounded, serious damage to internal components could occur.
Immobilizer and Data Interfaces
Many vehicles on the road manufactured after 1995 utilize some form of factory
security that requires a code that is passed between the key and the vehicle.
Different manufacturers use different methods to incorporate this into the ignition
cylinder of which RF or a key (or cylinder) impregnated resistor is the most popular.
These types of security are in place to disable the “cranking” of the motor and are
known as
Immobilizers
.
Data Interfaces
have become popular with aftermarket products as obd2 and
CANbus interfaces have evolved over the last 15 years. Aftermarket Data
Interfaces utilize analog wire signals from 2GO-Keyless™ system and translate
them into data that the vehicle can use to lock / unlock doors, monitor door open /
closed status, etc. In many cases Data Interfaces and Immobilizers are combined
into one unit and are manufactured by various aftermarket companies.
In vehicles manufactured after 1995 an
Immobilizer or Data Interfaces
module
may be necessary for the installation of Keyless Entry and Push Button Start of the
vehicle while maintaining all factory features. This manual will serve only as a
general guide to the installation of the 2GO-Keyless™ system, consideration of
Immobilizer or Data Interfaces devices and their installation should be done by a
professional.
If you need assistance locating an Immobilizer or Data Interfaces device for your
vehicle contact us at
(877) 2GO-KEYLESS or 877- 246- 5395
Summary of Contents for 2GO KEYLESS iKEY RS
