Digital Guard Dawg 2GO KEYLESS iKEY RS, Installation & User Manual

Page: 10 / 36

10
Door Lock & Alarm
~ Accessory Harness (7-Pin)
Wire Description
1
Red
Vehicle ON Detect
(+)
This wire is for sensing when the vehicle is ON. It should be
connected to an Ignition wire that has +12 V when the Ignition
Key or Push Button Start
is in the and
ON (RUN)
position.
Special instructions when using Remote Starter:
Connect to
different ACC wire if the vehicle has 2nd ACC.
2
Green
Door Trigger
Default
(-) Negative
This wire senses when a vehicle
“door open status”
. If you
have a negative-trigger door switch system, you can directly
connect this wire to the door switch signal wire.
If you have a positive–trigger or are not sure, refer to page 13 for
more information on door switch system trigger types.
Note:
Default function setting is Negative door switch. Change PKE
modules jumper (JP1) to Positive when vehicles use positive-
switch Dome Light circuit.
If a Data Interface is used, connect to modules “UNLOCK” input
wire.
3
Blue Connects to Window Rollup Module “Optional”
4
Brown
(+) Brake
This wire senses when you step on the Brake. The wire will be
+12V as you depress the brake pedal, and will be ground when
release brake.
5
Purple
This wire provides the data control signal for the 2GO-Keyless™
Push Button – Remote Start Module. Connect this wire to the
(Purple) input signal wire of the Push Button Start module.
6
White
OE Alarm
Factory Disarm
output (-)
If needed, this wire can provides a Ground when Armed or
Disarmed signal that can be used as a “Factory Disarm Wire” for
a OEM Alarm system
7
EMPTY