7
Control Module and Push Button Start Module:
Select a mounting location
behind the dash, and secure using cable ties. Be certain that the chosen location
will not interfere with the proper operation of the vehicle. Avoid mounting the
module to or routing the wiring around the steering column, as the module or wiring
could wrap around or block the steering wheel preventing proper control of the
vehicle. Do not mount the modules in the engine compartment, as it is not
waterproof.
Start Button:
The system Start Button is used to control your Start, ON, ACC &
STOP modes of your vehicle’s ignition system. In addition, the Start Buttons LED
provides a visual indication of when the system has recognized a valid RFID iKey™
and when the vehicle is ready to be started. Typically the Start Button is installed in
the dash or center console of the vehicle, but it can be installed in any location
within the length of the buttons 32” harness. Your choice of Start buttons will
determine the diameter and depth of hole needed for button installation. Be sure
and confirm that your have ample room behind the dash for the type Start Button
you have choose. Specific Start Button dimensions can be found on page 24 of this
manual.
Dash Mounted LED:
A dual color (Red / Blue) LED is also included in this kit. It
is a secondary visual indicator of the system mode. This LED is not required to be
used, but if installed will indicate when the systems alarm features Arm and Disarm,
as well as provide a “Flashing” warning to notify wood be thieves that your vehicle is
protected. If installing this LED, locate it where it can be easily seen from outside
the vehicle, yet not be distracting to the driver. Once a location has been selected,
check behind the panel for wire routing access, and confirm the drill will not damage
any existing components as it passes through the panel. Drill a 19/64” (7.6mm)
hole, and pass the wires from the LED through the hole, from the front of the panel.
Firmly press the body of LED into the hole until fully seated.
(Optional) Siren:
If you are installing a Siren instead of connecting to the
vehicle’s OEM horn, you will need to open the control module case and change the
systems jumper set (JP4) according the wiring diagram. * for more information see
“Jumper Sets” page 16. Always mount the Siren away from heat sources such as
radiators, exhaust manifolds and turbochargers. Mount it in an area where it will not
be in the way for mechanics and so that it cannot be easily reached from below the
vehicle. Mount it so that its sirens opening points down to prevent it from collecting
water.
Summary of Contents for 2GO KEYLESS iKEY RS
