RAID Array 410 to 450 Upgrade
4–20
EK–SM410–UP. A01
4.14
Removing Existing StorageWorks Manager
The RAID Manager and Monitor Utilities used with the V2.7 software and RAID Array
410 controller is not compatible with the upgraded V50 software and RAID Array 450
controller. Remove these utilities from your system as follows:
1. Exit the raidcf410 window if it is open from the FILE pull-down menu.
2. Stop the monitor utility (type “
/etc/init.d/raidmon_d stop
”).
3. Edit the .profile file in korn shell or .cshrc file in c shell to remove the path to the
utilities ($RAIDHOME410).
If you have a version of StorageWorks manager installed, then enter the following:
# pkginfo | grep DEC
you should then see:
DECptisp
DECswm410
or just:
DECswm410
depending on your specific host adapters.
First use the command:
# pkgrm DECswm410
then use the command:
# pkgrm DECptisp
to remove the existing software. It is not necessary to reboot at this point.
4.15
Installing StorageWorks Software:
To install the StorageWorks Software for Sun, follow the steps from the Getting Started-
RAID Array 450 V5.0 for Sun.
4.16
Congratulations
This completes the RAID Array 450 Upgrade Procedure. The system should be ready to
place on-line. If you cannot activate your system, specific troubleshooting or data
restoration may be required.
