Chapter 4. Sun Solaris
EK–SM410–UP. A01
4–5
4.3.4 Establishing Connection with a Maintenance Terminal
After connecting the maintenance terminal cable to the controller, press the Enter key.
The CLI prompt appears in the window similar to the following:
swxrc>
4.4
Recording Your Configuration Data
In the following steps, you need to record your configuration for use later in this
procedure.
4.4.1 For Either Single or Dual-redundant Controllers
First, verify the controller’s configuration:
swxrc> show this_controller full
Fill in the blanks below.
Controller:
SWXRC-04 ZG43700116 Firmware V27Z-0, Hardware A02
Not configured for dual-redundancy (or Dual-redundant configuration)
SCSI address 7
Time: NOT SET
Host port:
SCSI target(s) ________ Preferred target(s) ________
Cache:
32 megabyte write cache, version 2
Cache is GOOD
Battery is GOOD
No unflushed data in cache
CACHE_FLUSH_TIMER = DEFAULT (10 seconds)
CACHE_POLICY = _____
Host Functionality Mode = A
Licensing information:
RAID (RAID Option) is ENABLED, license key is VALID
WBCA (Writeback Cache Option) is ENABLED, license key is VALID
MIRR (Disk Mirroring Option) is ENABLED, license key is VALID
Extended information:
Terminal speed 9600 baud, eight bit, no parity, 1 stop bit
Operation control: 00000004 Security state code: 95018
Configuration backup disabled
