DIGITAL Laser Printer LN15 User Manual
3-10
Paper Feeder
If you switch paper sizes frequently, you may want to add a second paper
source. You can easily do this by installing an optional paper feeder
which consists of a base frame and a paper tray. The paper tray in the
paper feeder is identified as tray 2 and the one in the basic configuration
is identified as tray 1. The paper types and sizes used by tray 2 are the
same as those for the standard paper tray.
To install the paper feeder, follow these steps:
1.
Turn off the printer and
disconnect the power cord.
2.
Make sure the lock lever is
set to the open side.
Push
down the lever at the left side
of the paper feeder.
3.
Mount the printer on the
paper feeder.
Grip the
bottom left and right sides of
the printer to lift the printer
and place it on the paper
feeder. When placing the
printer on the paper feeder,
be sure you insert the two
guide pins of the paper feeder
into the two positioning holes
at the bottom of the printer.
4.
Set the lock lever to the lock
side.
Pull up the lever.
Notice:
Be careful not to drop the printer on the paper feeder.
Do not touch any connector contacts to avoid possible electrostatic
damage to the printer and paper feeder.
Adding Paper
Sources
Hold here (opposite
side as well)
Guide pins
Lock
lever
Paper
feeder
Summary of Contents for LN15
Page 1: ...DIGITAL Laser Printer LN15 User Manual...
Page 31: ...DIGITAL Laser Printer LN15 User Manual 2 7 Figure 2 2 Status report PS emulation...
Page 33: ...DIGITAL Laser Printer LN15 User Manual 2 9 Figure 2 3 Font report PS emulation...
Page 109: ...DIGITAL Laser Printer LN15 User Manual A 2 Scalable TrueType Fonts PS Mode...
