DIGITAL Laser Printer LN15 User Manual
3-4
Installing an
Interface
Expansion Board
☞
The printer’s standard interface is parallel. The available optional
interfaces are serial, LocalTalk, and Ethernet. If your computer cannot
use a parallel port for your printer or the location of your printer is
distant from the computer, you can use the serial port, LocalTalk port, or
Ethernet port of the computer to connect your printer. The optional
serial interface (RS-232C/422A) board, LocalTalk board, and Ethernet
board are suited for these purposes. Only one interface expansion board
can be fiited at a time.
Notice:
The DIGITAL Laser Printer LN15P is equipped with a Parallel interface
only. The interface slot is available for an optional interface. The
DIGITAL Laser Printer LN15N-A is equipped with a 10-Base-2
Ethernet interface installed and the DIGITAL Laser Printer LN15N-B is
equipped with a 10-Base-T Ethernet interface.
Installing an Interface Board
1. To install an interface board,
first make sure the printer is
turned off. Remove the
interface board slot cover
from the back right of the
printer.
2. Hold the board with the parts
mounting side left. Slide the
board into the empty
interface slot using the
guides, and push it until it
stops. Secure the board by the
two screws supplied with it.
Remove
the cover
Secure
screws
(Example: serial interface)
Summary of Contents for LN15
Page 1: ...DIGITAL Laser Printer LN15 User Manual...
Page 31: ...DIGITAL Laser Printer LN15 User Manual 2 7 Figure 2 2 Status report PS emulation...
Page 33: ...DIGITAL Laser Printer LN15 User Manual 2 9 Figure 2 3 Font report PS emulation...
Page 109: ...DIGITAL Laser Printer LN15 User Manual A 2 Scalable TrueType Fonts PS Mode...
