Digital Equipment Digital EtherWORKS 3 Turbo, User Information

Page: 57 / 66

Table A–2 (Cont.) Error Messages
Message Recommended Actions
Xmit Status, Xmit Valid bit not set
Xmit Status, SQE check failed
Xmit Status, ECL failed
Xmit Status, LCL failed
Xmit Status, ID failed
Xmit Status, NCL failed
Recv Status, IAM failed
Recv Status, MCM failed
Recv Status, PLL failed
Recv Status, CRC failed
Xmit Control, STOP test failed
Xmit Control, Q-Mode test failed
Xmit Control, PAD test failed
Xmit Control, IFC test failed
Xmit Control, ISA test failed
CSR, Runt Accept test failed
CSR, Promiscuous Mode Enable test
failed
CSR, Multicast Enable test failed
CSR, Transmit Not Empty bit failed
CSR, Receive Not Empty bit failed
CSR, Transmit Disable test failed
CSR, Receive Disable test failed
Transmit Packet Size over 1514
Receive Packet Size over 1514
Transmit Packet Size is zero
Receive Packet Size is zero
Transmit Failure
Receive Failure
Transmit Timeout
Receive Timeout
Refer to the Turbo board distribution
diskette file A:\Error.txt for more
information and troubleshooting
tips regarding the diagnostic error
message.
These errors are network-related
test failures. If your network
driver was installed before running
the diagnostics, power down the
PC and start again. If the error
messages persist, board may be
defective. Contact your Digital Sales
Representative.
(continued on next page)
A–9