Digital Equipment Digital EtherWORKS 3 Turbo, User Information

Page: 33 / 66

Default Settings
The Turbo board is preconfigured to work in most installations. If the
default settings are appropriate for your installation, you do not need
to change them. The default settings are summarized in Table 3–2.
Table 3–2 Default Settings
Menu Turbo, Turbo TP, and Turbo PLUS
I/O Base 300h
Memory mode 2 KB
Memory base D0000h
Memory address range D0000 - D07FFh
IRQ Selection IRQ5
Fast bus Disabled
16-Bit bus Enabled
Note
If a Turbo board is set to use a setting that another installed
board or resource uses, your computer or other boards may
not operate correctly when you boot the system. If you do
not know the settings for the other boards, check with your
system administrator for a list of the settings.
3–3