Tactic Any Link, Mounting Instructions

Page: 1 / 4

CHARGING THE BATTERY CHARGING THE BATTERY
1. IMPORTANT: Make sure the LiFe battery is fully
charged before use! Failure to do so could result
in AnyLink losing power during fl ight, causing
signal loss and crash of the model.
The lithium-iron phosphate (LiFe) re-chargeable battery has
a nominal rating of 6.6 volts and 200mAh of capacity. ONLY
use a LiFe compatible charger with this rated voltage, with
a maximum charge current rating of 0.2 amps (200mA).
Recommended chargers include the LiFeSource® AC/DC
Balancing Charger (HCAM6375), and the Triton
™ EQ and
Triton2 EQ chargers by ElectriFly® (GPMM3155, 3156). See
your local hobby retailer for details.
2. Make sure the Power Adapter is NOT connected to the
host transmitter when charging.
Power Connector
3. Connect the power connector to the charger. Always
observe the correct polarity and read the charger’s
instructions before attempting to charge the battery.
4. If the charger is designed for multiple chemistries, make
sure to set the charger to “LiFe” mode.
5. Set the charger’s output voltage to 6.6V. Do NOT set the
charger to a voltage greater than this, as an over-charge
condition may result in permanent damage to the battery
and its surroundings, and cause personal injury!
6. Set the charger’s output current to 0.2A or 200mA
maximum.
7. Start the charge process.
Refer to the SAFETY AND HANDLING INSTRUCTIONS FOR
LIFE BATTERIES section at the end of this manual, and
similar safety instructions included with the charger for
information regarding LiFe batteries.
MOUNTING AND CONNECTIONS MOUNTING AND CONNECTIONS
A. Using two pieces of hard lock mounting strips (included),
attach the Power Adapter to the rear of the Tx. Make sure
the Power Adapter’s connectors can easily reach the
AnyLink and transmitter’s trainer jack.
Signal Connector
B. Remove the protective boot from the signal connector.
Carefully insert the signal connector into the transmitter’s
trainer / D.S.C. jack. The Tx logic circuit will turn on
automatically at this time.
This Power Adapter allows the AnyLink SLT 2.4GHz Radio Adapter to function with the DX4e, DX5e, DX7s, DX8, and
DX10T transmitters from Spektrum®. The 6.6V lithium-iron phosphate rechargeable battery (LiFe) supplies power to
AnyLink, while the Tx draws power from its own battery.
Read these instructions – and the instructions included with the AnyLink adapter – entirely before
use! Damage resulting from misuse or modifi cation will void the warranty on the AnyLink SLT
2.4GHz Radio Adapter and this Power Adapter.
When fi nished reading these instructions entirely, return to the ANYLINK OPERATION section of the instruction manual
included with the AnyLink SLT 2.4GHz Radio Adapter. Finish reading those instructions entirely before use.
™
™