7.7.2 Making a Standard Network Connection at the DESQA Module
If your DESQA module does not have an Ethernet Connector switch, call
your Digital service representative.
If your DESQA module has an Ethernet Connector switch and you set it to
the in (standard) position:
1. Find the Ethernet transceiver cable. It has a plug at one end and a
socket at the other end.
2. Make sure the sliding lock on the standard Ethernet connector on the
module is in the up position.
3. Feed the plug end of the cable under the system from the back or side
and insert it into the connector as shown in Figure 29. Slide down the
lock to secure the connection.
Figure 29:
Making a Standard Ethernet Connection at the DESQA
Module
Feed Cable Under System
and Through Opening
MLO-005571
Standard
Ethernet
Connector
Sliding Lock
46
VAX 4000 Model 200 (BA430) Installation
