Digital Equipment 3100R Series, Service Maintenance Manual

Page: 75 / 174

Troubleshooting
4-27
D
IG
IT
A
L
S
er
ve
r
310
0R
/3
20
0R
RAID Troubleshooting
Problem Possible Cause Action
SCA-2 fault status LED lit. SCA-2 disk drive failed. Replace SCA-2 disk drive.
SCA-2 drive status and fault
status LEDs lit. SCA-2 disk drive hung or
has failed. Replace SCA-2 disk drive.
SCA-2 fault status LED
flashing. SCA-2 disk drive failed and
is spinning down. Replace SCA-2 disk drive.
SCA-2 fault status LED is
either on or off; fault status
LED flashing. SCA-2 disk drive is active
and spinning down due to a
fault. Correct the fault or replace the
SCA-2 disk drive.
Replaced SCA-2 disk drive
does not spin up to speed. SCA-2 disk drive not seen
by RAID adapter. Manually rebuild the SCA-2 disk
drive.
Remove the SCA-2 disk drive, wait
20 seconds, reinsert SCA-2 disk
drive. Wait one minute and then
rebuild the SCA-2 disk drive.
Multiple SCA-2 disk drives
have failed. No power available. Restore power, run the RAID
configuration utility and change the
state of any failed (FLD) SCA-2
disk drive to optimal (OPT).
Run the RAID configuration utility
and check for bad blocks on the
SCA-2 disk drives. Repair any bad
blocks.
SCA-2 disk drive not seen
by RAID adapter. SCSI cable not connected.
Incorrect SCSI termination.
Duplicate SCSI IDs on the
bus.
Defective SCA-2 disk drive.
SCA-2 disk drive
improperly inserted.
Defective RAID adapter
SCSI channels.
Check all SCSI connections.
Properly terminate the SCSI bus.
Check SCA-2 disk drive SCSI ID
settings.
Replace SCA-2 disk drive.
Reinsert SCA-2 disk drive.
Replace the RAID adapter.