Digital Electronics Corporation Pro-Face PL-6900 Series, User Manual

Page: 66 / 105

System Setup
5 - 5
PL-6900 Series User Manual
Boot Up Floppy Seek
Designates if the floppy disk drive installation check is used or not. The
available selections are [Disabled] and [Enabled]. [Enabled] is factory
set and recommended for most users.
Boot Up NumLock Status
Designates the condition of the NumLock key at startup. The two
selections are either [On] or [Off]. The [On] selection is factory set and
recommended for most users.
Boot Up System Speed
Designates the speed of CPU. [High] is factory set and recommended for
most users. The other available selection is [Low].
Gate A20 Option
The two selections available are [Fast] and [Normal]. When [Normal] is
selected, Keyboard Control is used for Gate A20 control. When [Fast] is
selected, the Chipset is used. The [Fast] selection is factory set and
recommended for most users.
Memory Parity / ECC Check
Designates if a Parity Check is used for Parity Memory. The two
selections available are [Disabled] and [Enabled]. The [Enabled]
selection is factory set and recommended for most users.
Typematic Rate Setting
Designates the repeat mode for characters on the keyboard. The
selections [Disabled] and [Enabled] are available. [Disabled] is factory
set and recommended for most users.
Typematic Rate (Chars/Sec)
When [Enabled] is selected on [Typematic Rate Setting], it designates
the actual rate (the number of repeating characters per second).
[6],[8],[10],[12],[15], [20],[24] and [30] are the available selections.[6]
is factory set.
Typematic Delay (Msec)
When [Enabled] is selected on [Typematic Rate Setting], it designates
the time until repetition of a character starts. The unit is mili-second
(msec). The available selections are [250],[500],[750]and [1000].
[250] is factory set.
Security Option
Designates the location of the Password Entry. The selection [Setup] is
for BIOS setup,and the other selection [System] is for both BIOS setup
and Start up.When the [Supervisor Password] or [User Password] has
not been designated, this setting is disabled. [Setup] is factory set and
recommended for most users.
PCI/VGA Palette Snoop
When the PCI/VGA and the MPEG ISA/VESA VAG cards are both
used, this setting is set to [Enabled]. In all other cases, this should be set
to [Disabled]. The [Disabled] selection is factory set and recommended
for most users.