VECTORDRIVE DSV 5445
Top technology in drive electronics
07.07.04 10:12
Dietz-electronic
page 52 of 60
9.1.3
Option card: 2 voltage-less contacts
Both independent relays operate a maximum of 60 W, coils 15 V DC/24 V DC selectable:
Terminal
Abbr.
Meaning
I/O-type
1
V1+
Relay coil 1 +
Input
2
V2+
Relay coil 2 +
Input
3
V-.
Relay coil 1 / 2
Input
4
PE
PE (earth)
Output
5
Ö1
Break contact 1
Output
6
W1
Change-over contact 1
Input
7
S1
Make contact 1
Output
8
Ö2
Break contact 2
Output
9
W2
Change-over contact 2
Input
10
S2
Make contact 2
Output
Data:
Bridges in basic setting:
relay coils 30 mA approx. at 15 V DC
if bridges are bidirectional:
relay coils 30 mA approx. at 24 V DC
Contacts per change-over contact with switching capacity of 50 W max. at 0.5 A max for 230 V AC or 48 V
DC at max. 0.5 A.
9.1.4
Option card: "SSI absolute value transducer input"
Pin assignment on option-card „SSI interface“ (95444439) for the DSV 5444 system (SSIIBSX3/04):
Accessories for "SSI Interface" option:
8042341
Flat strap cable connector 50 pole on 50 pole option -> VECTORDRIVE DSV 5444
8003039
15 pole SUB-D male connector; 8003042 Cover for this connector
8004074
95 pole SUB-D female connector; 8003041 Cover for this connector
95444813
0.6 m UD cable D 2nd transducer; 9 pole to 15 pole if required
Pin assignment on "SSI Interface" option card :
Plug-in connector "XA" (reproduction of EQN sine/cosine signal after "X3")
Pin 1 = UA1-OUT
Pin 2 = UA1-OUT\
Pin 3 = INT2-IN+
Pin 4 = INT2-IN-
Pin 5 = UA2-OUT
Pin 6 = UA2-OUT\
Pin 7 = GND
Pin 8 = GND
Pin 9 = GND
(„INT2“ is defined as
input as for
option 95444437)
