OPERATOR'S MANUAL
ERROR CODES/ 59
Dj SEED MANAGER® SE PLANTER MONITOR
BENCHMARK Series®
11001-1218-200112 Rev A
The Seed Manager® SE Console
performs a Self Test upon power up
and when commanded by the user in
SETUP MODE. At the end of the Self
Test the console will either show
PASSED and cycle through all of the
seed rows, or the console will display the
SELF TEST ERROR CODES
appropriate error codes that were
detected. Figure 66 shows a complete list
of all error codes that can be displayed.
See the TROUBLESHOOTING
chapter for additional details and
recommended recovery procedures.
Error Code
Description
E00
No Modules Connected
E01
Too Many Modules Connected on P1 or P2
E10
Too Few Seed Modules Connected
E11
Too Many Seed Modules Connected
E20
Too Few Shaft Modules Connected
E21
Too Many Shaft Modules Connected
E30 X
Too Few Seed Sensors Connected to Module X
E31 X
Too Many Seed Sensors Connected to Module X
E40
Too Few Hopper Sensors Connected
E41
Too Many Hopper Sensors Connected
E50
Too Few Pressure Sensors Connected
E51
Too Many Pressure Sensors Connected
E70
Module 8v Power Supply Too Low
E71
Module 8v Power Supply Too High
E98
Internal LCD Driver Failure
E99
Internal Bus Failure
Figure 66
Self-Test Error Codes