2/ INTRODUCTION
OPERATOR'S MANUAL
Dj SEED MANAGER® SE PLANTER MONITOR
BENCHMARK Series®
11001-1218-200112 Rev A
ON OFF
Pressing this switch applies power to the
monitor. Upon power up, the monitor
performs internal diagnostic checks,
illuminates all segments of the LCD,
sounds the alarm, and determines what
sensors are connected to the system.
Depressing the ON OFF switch for at
least one (1) second causes the system to
power down.
ALARM
Momentarily pressing this switch silences
the alarm and acknowledges the alarm
condition. Additionally, holding the
switch pressed for more than one (1)
second allows the volume level of the
alarm to be adjusted. As the switch is
held pressed, the alarm sounds continu-
ously and the volume level slowly
decreases to a minimum, then increases
to a maximum. Releasing the switch
establishes the desired volume level.
SETUP
This switch is pressed for one (1) second
to enter the Setup Mode and to step
from one Setup constant to the next as
detailed in the Setup Mode Chapter.
MIN AVG MAX SCAN
This switch is pressed to toggle between
the MIN AVG MAX and SCAN options
for Population and Spacing.
1 2 3 . . .
SELECT ROW
Pressing this switch while in Population
or Spacing functions freezes the display
on the current row data. Successive
depressions then cause stepping from
one row to the next. In the Setup Mode,
this switch allows stepping through the
rows while entering Row Status.
SELECT
SELECT
This switch is used to change constants in
the Setup Mode as explained in the
Setup Mode chapter. To move the
selected digit to the next digit, press the
SELECT switch.
SET
SET
This switch is used to change constants in
the Setup Mode as explained in the
Setup Mode chapter. To increase the
selected digit by one press the SET
switch. SET can also toggle a selection
between ON and OFF for example.