Elton User Manual Rev 1.04
Page 47
The Terminal will display the NVIDIA device listed under USB devices as shown below.
Figure 13.1-5: Device Detected on NVidia USB Bus Screen
To flash the AGX Xavier Series Module:
8. Type and
Enter
the following:
sudo ./flash.sh jetson-xavier-maxn mmcblk0p1
The flashing process will take 15-20 minutes to complete.
NOTE
: Do not interrupt or interfere with the USB connectivity or the power supply to Elton until the flashing
procedure is complete.
When the flashing is complete, the module will automatically Reboot.
On completion, a screen confirming a successful update to the module will be displayed as shown below.
Figure 13.1-6: Notification on Task Completion Screen
9. Power cycle the baseboard.
10. Remove the FORCE RECOVERY mode connections when powered OFF during power cycle.
11. Continue testing after system Restart.
