MODEL BGS-250 GRINDER
SECTION 6
OPERATION
33
Grinding & Polishing
OPERATING MANUAL
DECEMBER 2008
Pay attention to the following aspects during operation of the Diamatic BGS-250.
Before beginning the grinding work, verify that all bolted connections are properly
secured and tight, especially those of the driving and handling devices.
Before switching the machine on, make sure that all protective housings are fitted
and the dust collector is correctly connected.
Diamatic specially recommends operating the machine with only one dust
collector, which has enough suction capacity and high filtration efficiency.
Diamatic specially advises using a recommended Diamatic dust collector. This
ensures an appropriate airflow and adequate heat removal.
Handle all plugs, cables, hoses and operating elements carefully. Avoid contact
with live wires.
Before grinding, clean the surface to be treated with a broom. There should not
be any debris such as stones, cloths or standing liquid on the surface.
Any obstructions in the surface to be treated, like concrete reinforcing steel or
other objects, should be removed from the work surface to prevent damage to
the machine seals and diamond discs.
6.1 OPERATION
These Operating Instructions are to be kept with the machine
and must be within reach at all times.
Only trained personnel may be employed. Note the statutory
minimum age. Specify clearly the responsibilities of personnel for
operation, set up, service and maintenance work.
Make sure that only authorized personnel operate or work on the
machine.
Regular inspection is necessary to prevent unplanned down time
of your grinding machine. See Section 7.2 Maintenance.
