MODEL BGS-250 GRINDER
SECTION 5
INITIAL OPERATION
31
Grinding & Polishing
OPERATING MANUAL
DECEMBER 2008
Use the following sequence to start the machine:
•
Be sure that the grinding disc or cutter plate is fixed.
•
Connect dust collector to the grinder (1).
•
Switch on the dust collector.
•
Connect the machine to the electrical outlet with an extension cable that
complies with the appropriate European or U.S. NEC guideline, as
appropriate. Hang the extension cable on the support eye of the machine
(2).
•
Verify that the grinding disc is parallel with the floor using the mini leveler. Adjust
handle if necessary (3).
•
Push the start button. (4).
5.2 INITIAL OPERATION
Figure 5.2.1a: 110V 50 Hz / 230V 50 Hz / 400V 50Hz
Pay attention that you always lay down the machine on its
steering handle. If you lay down the machine on the grinding
disc, the flexible coupling could be deformed. That carries on a
one side wear of the grinding disc.
Figure 5.2.1b: 115V / 60Hz
3
2
1
