Dialogic® Diva® SIPcontrolTM Software Configuration
page 18
You may configure the parameters shown in the graphic and explained below:
Address Normalization
You may configure the parameters shown in the graphic and explained below:
Early B3 connect:
With this parameter you can determine if early media should be enabled on this controller
(EarlyB3) or whether early media should be enabled even if no "inband tones available"
signal is received from PSTN (EarlyB3ForceMedia).
The following values determine if EarlyB3 and EarlyB3ForceMedia are enabled or not:
Value
EarlyB3
EarlyB3Force
Media
auto
enabled
not enabled
on
enabled
enabled
off
not enabled not enabled
The default value is
auto
.
EarlyB3 default disconnect
timeout [s]:
Specifies the disconnect timeout value for early media calls to the PSTN, depending on the
received cause value. The disconnect timer is released if a call to the PSTN is terminated
before the receiver answers the call. This allows the caller to listen to a network
announcement describing the reason for the failure (e.g., "The number you have dialed is
not available. Please try again later.")
Default:
30
seconds
EarlyB3 disconnect timeout
[s] Cause <x>:<reason for
disconnect timeout>:
With these parameters, you may define the disconnect timeout for the different disconnect
timeout reasons. The default value for each reason is
30
seconds.
Dialplan:
Select the local dialplan to be used by the dialplan module of the Dialogic
®
Diva
®
SIPcontrol
TM
Software. The selected dialplan applies only to this controller.
In most cases, the PSTN interfaces within the system share a common dialplan of the local
environment, but configuring the dialplan per controller allows for handling variants, e.g., if the
controllers are connected to different PBXs or if one controller is directly connected to the public
network.
Configure the local dialplan as described under
on page 32 before you select it here.
