diagral DO220W, Manual

Page: 38 / 44

GB
Program the chosen zone or group code (series of 4 digits made up of “0” and “1”)
using the “0” and “1” keys on the detector as follows:
The chosen zone or group is now allocated to the detector. If you wish to modify this
allocation at a later date, carry out the procedure for programming the zone or
group again (once the detector has been opened).
FIXING AND TESTING
■
Fixing
➀
Determine the exact location of the
detector (see INSTALLATION PRECAU-
TIONS).
The magnet holder must be less than 5
mm from the detector and opposite the
integrated opening contact (align the verti-
cal notch on the magnet holder base with
the arrow on the detector base).
➁ Adjust the height of the magnet holder
➀
with respect to the contact detector
➁
as these joined pictures.
If necessary, use the shims
➂
supplied for
the magnet holder or place a shim under
the contact detector.
Start the
programming
by pressing both
the 0 and 1 keys
simultaneously
until the indicator
lamp goes out.
Press both
the 0 and 1 keys
simultaneously
again until
the indicator
lamp goes out.
Confirm programming
by pressing both
the 0 and 1 keys
simultaneously until
the indicator lamp
goes out. The indicator
lamp lights up for 5 s to
indicate programming
has been successful.
Carry out the
4 successive short
presses correspon-
ding to the code of
the zone or group.
The red indicator
lamp lights up each
time a key is
pressed.
notch-arrow alignment
Max :
5 mm
Max : 5 mm
35 mm
➀
➂
➁
For the detector to function
correctly, lateral alignment and
correct height adjustment are imperative.
!
38