diagral DO220W, Manual

Page: 37 / 44

37
GB
■
Testing the customized radio code
➀
Briefly press the “Test” button on the detector and check that the
control panel:
●
emits an audible signal and an indicator lamp on the control panel
lights up,
●
or gives a voice message “Group X Intrusion” .
➁ If your control panel does not respond as it should, carry out the
detector coding again. If the problem persists, re-code the control panel
and try again.
You have allocated your customized radio code to your detector.
■
Allocating the zone or group
The detector is factory allocated to “zone 1” or to “group 1 immediate”.
This allocation can be kept or modified according to the following table:
Zone 1
or
Group 1
immediate
Active in Partial
and Total operation modes
Immediate triggering Active in Group 1 operation
mode
Immediate triggering
Zone
or
Group
Detector operation
with a control panel in
Partial/Total operation mode
with a control panel in
Independent groups mode
Code
Zone 2
or Group 1
time
delayed
Active in Partial
and Total operation modes
Immediate
or time delayed triggering Active in Group 1 operation
mode
Immediate
or time delayed triggering
Zone 3
or
Group 2
immediate
Active in Total operation mode
Inactive in Partial operation mode
Immediate triggering Active in Group 2 operation
mode
Immediate triggering
Zone 4
or Group 2
time
delayed
Active in Total operation mode
Inactive in Partial operation mode
Immediate
or time delayed triggering Active in Group 2 operation
mode
Immediate
or time delayed triggering
0 0 0 0
0 1 0 0
1 0 0 0
1 1 0 0
If you are adding to your system, you must first of all put the control panel
into test mode in order to carry out this test. Refer to the alarm system
installation guide.
!