36
GB
FIG. E
Code your detector
Program your customized radio code by successive presses of the
“0” and “1” keys, then program the zone (or group) allocated to
your detector.
■
Programming the customized radio code
➀
Check the boxes in the 1st line of the table corresponding to the customized radio
code of your control panel (see the Choice of radio code chapter in the installation
guide).
➁
On the 2nd line of the table write a “0” (zero) below each cross.
➂
Fill in the empty boxes on the 2nd line with “1” (one).
You will obtain a series of 10 digits made up of “0” and “1” that corresponds to the
code to be programmed into your detector.
➃
Program the radio code by pressing the “0” and “1” keys on the detector as des-
cribed below:
E
Hold the detector in your hands during programming,
making sure that you do not press the test button.
!
“1”
indicator lamp
“0”
Start the
programming
by pressing both
the
0
and
1
keys
simultaneously
until the indicator
lamp goes out.
Confirm programming
by pressing both
the
0
and
1
keys
simultaneously until the
indicator lamp goes out.
The indicator lamp lights up
for 5 s to indicate program-
ming has been successful.
Carry out the
10 successive short presses
corresponding to the detector
code. The red indicator lamp lights
up each time a key is pressed.
In the event of a programming error, the red indicator lamp flashes;
reprogram the unit again from the beginning.
!
1
2
3
4
5
6
7
8
9 10
Customized radio code
Detector code
Summary of Contents for DO220W
Page 44: ...804979 A DIAGRAL 01 2011...
