Dhollandia DH-RM.25, Installation Manual, Page: 51 / 79

50
DHOLLANDIA

Since the platform has a lower travel position under the extension plate [distance Y on fig. Figure 16.3], the arms and platform
knuckles will come out further over a distance X [Figure 16.3].

If not premounted, install the 114mm spacer tubes between the side steps and rubber buffers by means of the bolts M10x170
supplied with the kit.

Consult next page for general overview.
Figure 16.3
17 LUBRICATION INSTRUCTIONS

All articulation points equipped with lube fittings should be lubricated after installation (pictured on the following page), and once
in service with intervals as indicated in the maintenance manual.

Use a grease gun to pump grease in the lube fittings, until a grease collar is formed on both sides of the bearing or articulation,
protecting it against ingress of water, salt, sand and dirt.

Note that the grease nipple might be located in the pin itself, or in the larger assembly that pivots around the pin.

In case a pin has 2 grease nipples, grease both sides.

Ensure all lube fittings function correctly and replace any defective fittings.

ALWAYS use acid-free grease. The use of graphite grease is not allowed.

If so equipped, verify if the platform lock operates smoothly, and lubricate with oil if necessary.
NOTICE
To maximize the durability and operational reliability of the tail lift, it is important to lubricate the pivot points thoroughly after
installation.
114mm