Dhollandia DH-RM.25, Installation Manual, Page: 17 / 79

16
DHOLLANDIA
Figure 6.5
Figure 6.6

The tail lift is equipped with bolt-on mounting plates, adjustable in width for chassis width 790mm < W < 1290mm.

The mounting plates don’t require any welding [see Figure 6.6].

Refer to Figure 6.6 for the min. body width BWO MIN. required for installation with pre-mounted pump unit.
NOTICE

If you decide to remove the mounting bar and change the mounting height MFT of the tail lift, ensure to stay within the
applicable ranges for the installation parameters VFH, MFT and MTG.

Consult the national DHOLLANDIA distributor for confirmation of max. and min. mounting dimensions and obtain a chassis
cut-out drawing for the new mounting height MFT.

Mounting height MFT is measured from the top of the vehicle bed to top of the main frame tube. Use [Figure 6.5] when
determining mounting height MFT, make sure the height of the RUPD complies with regulations.
Dimensions table
mm
A 190
CHW MIN 790
CHW MAX 1290
BWO MIN 2240
A