MA_ENG_REV_User Manual Revelation_REV 1508
28
It does not do much more than connect to the driver for checking purposes or to change settings in
the driver. These changes will apply for all programs that use the board and this driver.
You should start Revelation II in DGT Bluetooth e-Board mode to access the board over the Bluetooth
connection. (Start while holding
)
The main window will show the board. When the proper COM Port number is not yet chosen, there
is a good chance that there are no chess pieces shown. It is a good idea to place all chess pieces on
the Revelation II board in this phase. You can verify then if all pieces are placed and detected
correctly.
Click on the “Settings” menu and chose “Configure
driver”
Then chose the “Connection” Tab first.
Select one of the ports that have a suffix (BT).
After a few seconds (up to 15) the big square should
turn green and show “Board alive”. The green square
on the right hand side indicates that a clock is found
too. Revelation II has a built in chess timer so no
external clock is required.
Please note that this window may be smaller on your
computer and will not show all tabs. Two arrows will be
shown in the upper right corner that will allow you to
scroll horizontally. See the red arrow.
