www.dfi .com
19
Chapter 2 Hardware Installation
Chapter 2
USB Ports
USB 1
USB 0
USB 3.0
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The system board is equipped with four onboard USB 3.0 ports (USB 0-1/2-3) and one vertical
USB 2.0 port (USB 5) for security drive. The 10-pin connectors allow you to connect 4 addi-
tional USB 2.0 ports (USB 0-1/2-3). The additional USB ports may be mounted on a card-edge
bracket. Install the card-edge bracket to an available slot at the rear of the system chassis and
then insert the USB port cables to a connector.
Wake-On-USB Keyboard/Mouse
The Wake-On-USB Keyboard/Mouse function allows you to use a USB keyboard or USB mouse
to wake up a system from the S3 (STR - Suspend To RAM) state. To use this function:
• Jumper
Setting
JP8, JP9, JP10 and JP11 must be set to “2-3 On: +5V_standby”. Refer to “USB Power Select”
in this chapter for more information.
USB 3
USB 2
USB 3.0
USB 2-3
USB 0-1
9
VCC
-Data
+Data
GND
Ke
y
VCC
-Data
+Data
GND
N.C.
10
2
1
USB 2.0
USB 5
1
4
VCC
GND
-Data
+Data
USB 2.0
