DFI 686IPK, User Manual, Page: 54 / 78

54
If this category is set to PCI Slot 1/2/3/4 or PCI-Auto, the Primary and
Secondary IDE INT# categories will appear allowing you to select the
PCI interrupt (A, B, C, or D) that is associated with the connected hard
drives.
Assign IRQ for VGA
If Enabled, the system will automatically set an IRQ for the VGA card
installed. Your VGA card will need an IRQ address only when using the
video capture function of the card. If you are not using this function and
a new device requires an IRQ address, you can set this function to
Disabled. The IRQ address (previously occupied by the VGA card) will
be available for your new device.
Load BIOS Defaults
The “Load BIOS Defaults” option loads the troubleshooting default val-
ues permanently stored in the ROM chips. These settings are not opti-
mal and turn off all high performance features. You should use these
values only if you have hardware problems. Highlight this option on the
main menu and press <Enter>. The message below will appear.
Load BIOS Defaults (Y/N)? N
If you want to proceed, type <Y> and press <Enter>. The default set-
tings will be loaded.
Load Setup Defaults
The “Load Setup Defaults” option loads optimized settings from the
BIOS ROM. Use the Setup default values as standard values for your
system.
Highlight this option on the main menu and press <Enter>. The mes-
sage below will appear.
Load Setup Defaults (Y/N)? N
Type <Y> and press <Enter> to load the Setup default values.