DFI 686IPK, User Manual

Page: 24 / 78

24
4. Install the HSS Base by pushing each side down firmly into the
holes on the system board. (The HSS Base can only be installed in
one direction). Make sure it locks into place.
5. Replace the HSS Pins on each end of the HSS Base. These pins
will insert through the HSS Base to secure it to the system board.
6. Hold the processor and push the latches toward the center of the
processor until they click into place.
3. Remove the HSS Pins located on each end of the HSS Base.
7. Hold the processor so that the heatsink is facing toward the HSS
Base on the system board. Slide the processor into the Retention
Mechanism. Ensure that the alignment notch in the processor fits
into the plug in Slot 1. Push the processor down firmly, with even
pressure on both sides of the top, until it is seated.