DewertOkin ID21, Installation Instructions Manual

Page: 60 / 96

Operating the control keypads System ID21
60 78438 7.0
8.5.2 Display functions
The display on the HSF control keypad is a three-character positional and information display.
There are also 6 information LEDs arranged side-by-side.
LED Function
Container LED
This LED indicates that the container stop is enabled. (Depend-
ing on control unit model in use.)
Reset LED
This LED indicates that a control unit reset is being carried out.
(Depending on control unit model in use.)
Flex LED
This LED indicates that the Flex function is enabled. (Depending
on control unit model in use.)
Ergo-trainer LED
This LED indicates that the ergo-trainer is enabled. (Depending
on control unit model in use.)
Info LED
This LED indicates that important information is displayed on the
positional/information display. (Depending on control unit model
in use.)
PIN LED
This LED indicates that the PIN CODE function is enabled.
8.5.3 Advanced functions
Saving a position
Any table position can be saved using this function.

When the control unit is turned on for the first time, all positions are equal to the smallest
table position (the lower end position).

Only one table position can be stored per memory key.
To save a position, proceed as follows:
1 Move the table to the position that you want to save.
073 The position is shown on the display (e.g. 73 cm).
2 Press the Save key.
5 -
S – is now shown on the display.
3 Press the desired memory key (e.g. 2).
5 2
S 2 is shown on the display.
4 The set table position is now saved for the selected memory key.
A double-click noise can then be heard. After about 2 seconds, the saved
table position is displayed.