DewertOkin ID21, Installation Instructions Manual

Page: 43 / 96

System ID21 Installation
78438 7.0 43
5.6 Mounting the sensor unit
5.6.1 SMARTneo-pro control unit
The SMARTneo-pro control unit can be equipped with a protective mechanism. For this purpose,
the sensor is mounted under the table top between the table frames.

The sensor is attached to both the table frame and the tabletop. The contact point with the
tabletop is marked with a yellow dot, as shown in Figure 41.
Figure 41 Sensor
A
Sensor
B
Connecting cable (connection to the
SMARTneo-pro control unit)
NOTICE
This protective mechanism only works when the sensor is correctly installed. Make sure that the
side of the sensor marked with a yellow dot is facing the tabletop.
CAUTION
•
You should only install and remove the sensor when it is completely disconnected from any
live current!
• This safety mechanism is not effective unless the drilled holes are aligned exactly with each
other. Personal injury and property damage can result from improper alignment.

The screws are not included in our delivery.
B
A