DewertOkin ID21, Installation Instructions Manual

Page: 36 / 96

Installation System ID21
36 78438 7.0
5.4 Installing the SMART/COMPACT control units
NOTICE
Please observe the thickness of the tabletop.

Mount the control unit under the centre of the table. The best installation position is be-
tween the table frames. Be sure to note the length of the connecting cables during the in-
stallation.

Use 4.8xL raised-head screws (according to requirements of DIN 7981) with a 9.5 mm
head diameter and of suitable length (2 mm + screw-in depth into the table). Tighten the
screw using a maximum torque of 2 Nm.
CAUTION
You should only install and uninstall the control unit when it is completely disconnected from any
live current!
Install the control unit as shown in Figure 33 (control unit SMARTeco), Figure 35 (control unit
SMARTneo / SMARTneo-pro) or Figure 37 (control unit COMPACT):
1
Mark the drill holes. The drilling dimensions are specified in Figure 32 (control unit SMARTeco),
Figure 34 (control unit SMARTneo / SMARTneo-pro) or Figure 36 (control unit COMPACT).
2 Use a suitable drill to drill the two holes.
3 Screw the control unit onto the tabletop.
4 Route all connecting cables under the tabletop so that they cannot be pinched during the table's
lifting movements.