Devolo MicroLlink, User Manual

Page: 24 / 67

AT commands: Detailed description
|
|
devolo MicroLink ISDN i
|
24
EN
The terminal selection digit is accepted as follows:
Example If you wish to assign EAZ 8 enter the following command:
AT$IEAZ=0,2,"8"
Use the command AT$IEAZ=0 ,"" to delete the EAZ. No EAZ is assigned to
the MicroLink ISDN i by default. All calls are thus answered.
$IMSN Call acceptance from Multiple Subscriber
Numbers (MSNs)
AT$IMSN=p,<"MSN1">,<"MSN2">,<"MSN3">
This command is only relevant for the DSS1 protocol (Euro-ISDN). This com-
mand can be used to restrict call answering. If no multiple subscriber number
(MSN) is specified here, all calls will be answered, regardless of the target
dial number specified for the incoming call. A maximum of three caller IDs
can be stored. The caller ID may consist of a maximum of 20 digits (0 to 9).
No further commands can be executed from the same command line after this
command.
Incoming calls without stated target dial numbers will always be answered.
All changes are automatically recorded in the nonvolatile memory and are
preserved until the next change
n
Terminal selection digit used for
incoming calls Terminal selection digit used
for outgoing calls
0
1 to 9
10 to 19 0
0 and corresponding 1 to 9
corresponding 0 to 9 0
corresponding 1 to 9
corresponding 0 to 9
Parameter Value Description
p 0 Port 0 (V.24 interface)
<"MSN1"> 0..9 Store 1st MSN
<"MSN2"> 0..9 Store 2nd MSN
<"MSN3"> 0..9 Store 3rd MSN