Devolo MicroLlink, User Manual

Page: 23 / 67

|
AT commands: Detailed description
23
|
devolo MicroLink ISDN i
|
EN
This command is used to set the D-channel protocol. The adjustment may not
be made during a connection or with a call pending. All changes are auto-
matically recorded in the nonvolatile memory and are preserved until the next
change.
Example To set the MicroLink ISDN i to the 1TR6 protocol, enter the following com-
mand:
AT$IDP=1TR6
The MicroLink ISDN i is set to the DSS1 protocol by default.
The DSS1PP may interfere with other units on the same ISDN Basic Rate
Interface. This protocol should only be selected when using an ISDN
point-to-point connection.
$IEAZ Setting the terminal selection digit (EAZ)
AT$IEAZ=p,<"EAZ">
This command is only relevant for the German national protocol (1TR6). If the
command is entered in the DSS1 mode, it will not become valid until switch-
ing to the 1TR6 protocol. This command is used to determine which terminal
selection digit should be used to answer incoming calls.
In addition, the terminal selection digit used for outgoing calls is also estab-
lished. All changes are automatically recorded in the nonvolatile memory and
are preserved until the next change.
Parameter Value Description
<Value1> DSS1 Euro-ISDN (DSS1 protocol)
1TR6 German national ISDN (1TR6 protocol)
AUTO Automatic setting of the D-channel protocol
Parameter
Value Description
p 0 Port 0 (V.24 interface)