Motion Sensor - MOSZB-130 – Technical manual
Develco Products A/S
Olof Palmes Allé 40
http://develcoproducts.com
DK-8200 Aarhus N
13
Bit0, Bit2:
Note: How to clear a alarm in the “Zone status”
The sensor requests ZCL Default Response on the Zone Status Change notification, if any new Alarm
bit has been set. Until the IAS CIE has acknowledged the received alarm by sending the mandated
Default Response, the Alarm bits are not cleared – even if there is no longer an alarm situation on
either tamper or movement. When the Default Response is received, a new Zone Status Change
notification is sent with the Alarm bits cleared, if the alarm situation has disappeared since sending the
Zone Status message with alarm set.
Bit3:
When the battery is below
2.5 VDC.
Battery bit is set high and “Zone Status” is transmitted to the coordinator.
Bit9: When the battery is defect the sensitivity of the motion detector is reduced to avoid false alarms. Therefore
when this bit is true it is highly recommended that the battery is changed.
4.2.2
Power Configuration - Cluster id 0x0001
The power configuration cluster is described in ZigBee Cluster Library Specification
4.2.2.1
Attribute
Id#
Name
Type
Range
Man/Opt
Relevance and ref.
0x0020 BatteryVoltage
Uint8
0x00 - 0xFF
O
ZCL configure reporting is
supported
0x0031
BatterySize
enum8
CR123A
(0x08)
O
0x0033
BatteryQuantity
Uint8
1
O
0x0034
BatteryRatedVoltage
Uint8
30
O
Unit is in 100 mV
0x0036
BatteryVoltageMinThr
eshold
Uint8
25
Unit is in 100 mV
0x003E
BatteryAlarmState
Map32
O
Bit0:
BatteryVoltageMinThreshold
Is set if BatteryVoltage has
been
below
BatteryVoltageMinThreshold
or other internal circuits has
deemed the supply to be
inadequate.
This bit will only reset after a
power cycle.
