Motion Sensor - MOSZB-130 – Technical manual
Develco Products A/S
Olof Palmes Allé 40
http://develcoproducts.com
DK-8200 Aarhus N
19
Default – 1 movement
4.3.1.2
Manufacture Specific Attribute
Id#
Name
Type
Range
Man/Opt
Relevance and ref.
0xFC00
ArmThreshold_
MinTemperature
Sint16
0x954d –
0x7ffe
M
Write/read is supported
0xFC01
ArmThreshold_
MaxTemperature
Sint16
0x954d –
0x7ffe
M
Write/read is supported
0xFC02
TargetLevel
Uint16
0x0002 –
0xfffd
M
Write/read is supported
ZCL header setting – Manufactor code for Develco Products is 0x1015
4.3.2
Occupancy Sensor using temperature sensor input
End point 0x22, 0x28 and 0x29 can be configured as a logic module that controls the occupancy sensor signal
base on the user defined settings for the temperature sensor input.
Logic module
If
(Temperature >
ArmThreshold_MaxTemperature
)
or
(Temperature <
ArmThreshold_MinTemperature
)
Temperature measure value
Cluster ID 0x0402
Attribute ID 0x0000
Occupancy state
Occupancy state
Use case – Energy savings in an office building
The device is installed to obtain energy savings in an office with an air condition. A ZigBee relay is installed to turn
on the air condition when the occupancy sensor detects movements in the room. This functionality can be
obtained by using the standard occupancy sensor functionality – Standard ZCL attributes.
Using the manufacture specific attributes in section 4.2.1.2 provide the user with an extra check before the air
condition is turned on.
The installer can configure the ArmThreshold_MaxTemperature attribute to 25 degrees and when movements are
detected in the room the relay only turns on the air condition when the temperature is above the MaxTemperature
Setting (25 degrees).
