Motion Sensor - MOSZB-130 – Technical manual
Develco Products A/S
Olof Palmes Allé 40
http://develcoproducts.com
DK-8200 Aarhus N
20
The ArmThreshold_MinTemperature attribute can be used in winter season where the air condition shall warm up
the room. The MinTemperature attribute is configured to 20 degrees and when movements are detected in the
room and the temperature is below MinTemperature the air condition is turned on heating the room.
20 degrees
MinTemperature
25 degrees
MaxTemperature
Air Condition
OFF
Air Condition
ON
Cooling
Air Condition
ON
Heating
Temperature
4.3.3
Occupancy Sensor using illumination sensor input
End point 0x22, 0x28 and 0x29 can be configured as a logic module that controls the occupancy sensor signal
base on the user defined settings for the illumination sensor input.
Logic module
If Illumination is
X < TargetLevel
Illuminance measure value
Cluster ID 0x0400
Attribute ID 0x0000
Occupancy state
Occupancy state
Use case – Energy savings in an office building
The device is installed to obtain energy savings in an office controlling the light. A ZigBee relay is installed to turn
on the light when the occupancy sensor detects movements in the room. This functionality can be obtained by
using the standard occupancy sensor Standard functionality - ZCL attributes.
Using the manufacture specific attributes in section 4.2.1.2 provide the user with an extra check before the air light
is turned on.
The installer can configure the
TargetLevel
attribute to a user defined Lux level. When movements are detected in
the room and the Lux level is below the
TargetLevel
the relay turns on the light.
